Industry Insights
·
Foam Density Explained: Why 35kg/m³ HR Foam Matters for Compressed Sofas

When a sofa is vacuum-sealed and sits in a container for 30–45 days, its foam is under sustained pressure the entire voyage. Whether it springs back or arrives permanently flattened depends almost entirely on one number: density, measured in kg/m³.
Budget seating foam at 25–28 kg/m³ is common in low-cost residential furniture, but its cell structure breaks down under prolonged compression. High-resilience (HR) foam at 35–45 kg/m³ behaves like a spring: the denser cell walls allow a recovery of 95–98% of original volume within 48–72 hours of unboxing.
A useful industry benchmark: recovery above 95% within 48 hours. Anything below that threshold signals foam that will sag within a year or two of daily use — a complaint that lands on the importer, not the factory.
Density must be written into the bill of materials, seat by seat. One sofa legitimately carries several grades — seat cores, back cushions, and armrests often differ — so a spec sheet that only says “comfortable” protects nobody. Ask for the foam supplier’s data sheet and keep it with the order file.
Verification is cheap insurance: weigh or cut foam samples on the factory floor before compression, and request a pre-shipment mock-up where one unit is compressed, stored for 30 days, then unboxed to observe recovery before the bulk order ships.
Leave a Reply